Table of Contents
Advertisement
Water
distribution
tube
Water
Water line
System
Silica gel tubes
Water
valve
Floater valve
3. Ice Cube is not OK
P
roblem
Check part
k
inds
or point
Condenser
The ambient
Cubes are
temperature
too small
Electronic
control box
Refrigerant
Electronic
control box
Cubes are
Sensor
too big
The ambient
and water
temperature
Water quality
The cubes
are partially
Evaporator
formed--hav
Water
e ragged
distribution
sides or
tube
white and
The water
deformity
pump
The water lack
Water trough
The water distribution
tube blocks
The water quality is too
poor.
The
blocks
The
silica
distort, lead to block.
dump
The water dump valve
bad, the water leakes
The floater valve leaks.
Lead to few ice produced.
Possible Cause
The condenser is dirty or
the air grills are covered
The ambient temperature
is too high.
The setting temperature
is high.
Refrigerant leaks
The setting temperature
of Electronic control box
is low.
Temperature sensor of the
evaporator damages
The ambient temperature
and water temperature is
too low.
The water quality is poor
Ice machine is dirty
The water distribution
tube blocks partially
The water pump is dirty
The water floater is bad
Water trough level is too
low
Clean the water distribution tube
Using a filter apparatus installed in
front of the water inlet valve.
water
line
gel
tubes
Make the silica gel tubes resile
Replace the water dump valve
Repair or replace
Clean the condenser. Leave space
around the machine
Adjust the ambient temperature.
See the service manual "adjust the
size of ice cubes"
Recharge.
See the service manual "adjust the
size of ice cubes"
Replace the sensor of temperature.
Adjust the temperature.
Using
apparatus installed in front of the
water inlet valve.
Clean and sanitize the ice machine
Clean the water distribution tube
Clean the water pump inside
Replace the water floater
Adjust the water floater
Probable Correction
a
water-soften
/
filter
10
Advertisement
Table of Contents
