CEStronics Omega Flex Fitting And Operating Instructions page 24

Fitting and commissioning
5. Learn your locking devices to the radio switch:
Fig. 8 - Set the radio switch into
learning mode
In response, the RF Switchpoint signal changes from red to
green. The RF Switchpoint is now in its learning mode. The green
LED will flash regularly for up to three minutes.
Fig. 9 – Enable the locking device
In response, the device LEDs emit a long (2 seconds) green
signal. The device is now in its learning mode.
Condition: The RF-INI-Master must have been
enabled with the System-Master.
To end the learning mode, press the button again (1).

This is acknowledged by four short consecutive flashes of the
green LED of the radio switch.
If no cylinder is enabled, the red LED emits four short
consecutive flashes and the previous grouping will be reset.
Page 24 of 51
Establish any required

connections and activate the RF
Switchpoint.
Wait for the start-up phase of

the radio switch to be
completed (about ten seconds).
Set the radio switch into its

learning mode by pressing the
button (1) on the board of the
RF Switchpoint for a short
period.
Enable the locking device with

the RF-INI-Master by holding in
front of the locking device (a
maximum of four devices can
be enabled).
OMEGA FLEX Radio switch