Motor Mode - Tele System TS3010HD User Manual

TELE System
CAUTION!
If the signal Strength and Quality bars at the bottom of the screen do not respond or indicate low level, make sure the
parameters have been entered correctly and that the selected TP is not out-of-date.
Satellite channels scan
To conduct a channel scan on the selected satellites:
Press the BLUE Scan button
•
Define the following in the Scan mode screen:
•
1. Scan Mode : scan the Transponder database ( Default ) or by a Blind-scan ( Blind-Detail ) or by network.
2. Crypted : choose Free Only to scan only free channels (recommended) or All for coded channels as well.
Service type : choose All, only TV (DTV) or only Radio (Radio).
3.
Press OK to start scan
•
•

3.3.1.3 Motor Mode

This receiver can command a motorised antenna either manually (using the DiSEqC 1.2 protocol) or semi-automatically
(using the USALS (DiSEqC 1.3) protocol), depending on the type of motor used in the plant.
To use this mode, it is necessary to set the Motor to DiSEqC 1.2/ DiSEqC 1.3 .
3.3.1.3.1 DiSEqC 1.2
Set limit
Set Motor to DiSEqC 1.2 and then press Set Limit (RED button) to enter the motor setup interface and define the
following:
1. Move Continue : adjustment of the antenna position
2. Move Step : Step adjustment of the antenna position
Set West/East Limit : define left/right rotation limits for the motor
3.
4. Goto reference : recalls the default motor position.
5. Disable limit: delete the left/right rotation limits for the motor
Antenna and satellite setup
1. Satellite : Select satellite name (i.e. HotBird 13°E). Press OK button then ►.
2. LNB Type : set Local oscillator frequency (Low/High Freq). Change the LNB frequency type using ◄/►. (i.e. In Italy,
a typical setting is 9750/16600 )
3. LNB Power : Power control for switching H/V polarity
4. 22K Tone : 22KHz signal to switch between high and low frequency bands.
5. Toneburst: Off
DiSEqC1 .0: none
6.
7. DiSEqC1 .1: none
8. Motor: DiSEqC 1.2
9. With the command line positioned on MOTOR item, press Ok button to enter the Set Position menu, which allows
you to define the position of the selected satellite
1. Move Auto : auto adjustment of the antenna position
Move Continue : adjustment of the antenna position
2.
Move Step : Step adjustment of the antenna position
3.
Store Position : store the position of the selected satellite
4.
Goto Position : recalls the motor position saved for the selected satellite.
5.
Goto reference : recalls the default motor position.
6.
7. Press EXIT twice to save settings and return to the previous screen
Satellite channels scan
To conduct a channel scan on the selected satellites:
Press the BLUE Scan button
•
Define the following in the Scan mode screen:
•
1. Scan Mode : scan the Transponder database ( Default ) or by a Blind-scan ( Blind-Detail ) or by network.
Crypted : choose Free Only to scan only free channels (recommended) or All for coded channels as well.
2.
Service type : choose All, only TV (DTV) or only Radio (Radio).
3.
Press OK to start scan
•
10