Schroeder America ARIZONA TEA DISPENSER 925 Installation Instruction, Parts List And Configuration Manual page 4

Be sure to lock inlet line fitting into FCM/MM module assembly using
F. See above
G. Turn on water and syrup at source.
H. Turn on water and syrup to flow controls by rotating yellow Shut-off knobs (see Fig. 3.1).
I. Check for leaks.
J. Remove nozzle and install ratio separator.
K. Dispense about two (2) cups and dispose. Using a ratio cup check ratio. If not in spec, use a
small screwdriver to adjust. Clockwise increases flow. Counterclockwise decreases flow.
L. Unit is now operational.
4. RATIO/BRIX
The Schroeder America Dispenser has been thoroughly tested and sanitized prior to shipment. The
installer will be required to ratio/brix the dispenser. A Schroeder America Dispenser syrup separator
or refractometer may be used.
Sugar free products require a syrup separator. Installer must cool or chill the product before
brixing the system. Ratio will be different between cold product and warm product.
BEFORE RATIO/BRIXING SYSTEM, PURGE PRODUCT AND WATER THROUGH
THE TEA URN DISPENSER TO ENSURE PROPER PRODUCT TEMPERATURE.
A. To adjust water flow rate, turn off syrup side by rotating the yellow Shut-off, then pull handle
to purge any remaining tea concentrate until clear liquid is dispensed. Capture water in a
graduated cylinder (oz.) or measuring cup while timing the dispense. Divide the volume (oz.) of
water by the time. This will equal the flow rate.
The Schroeder America Tea Dispenser is designed to flow 2.4oz/sec. or 12oz/5 sec.
B. To adjust flow control assembly, remove the red cap to expose the slotted yellow adjustment
screw (Fig. 4.1). To regulate flow, turn clockwise to increase flow and counterclockwise to
decrease flow. If the flow control assembly contains a slotted green adjustment screw, it is
mechanical. To regulate flow, turn counterclockwise to increase flow and clockwise to decrease
flow (opposite flow control).
4
On
Fig. 3.1
the red retainers before introducing product and water.
IMPORTANT
This is the proper setting for 5:1 ratio.
NOTE:
NOTE:
NOTE:
Off