Routing Audio Through An Effect - Yamaha DM2000V2 Quick Start Manual

ROUTING AUDIO THROUGH AN EFFECT

1.
First, audio needs to be routed into the effect. If the default patch is used, first turn up Aux 1 send level for the
required channel.
2.
Check that the Aux 1 Master fader is up to 0dB (that is its default position).
3.
Already audio should be seen on the level meters of Effect 1. You can see the meters on the top-right corner of
the FX EDIT page.
4.
Then push up faders 73 and 74 to start hearing the effect's output in the Stereo bus.
1
3
2
4
21/28
DM2000V2 Quick Start Guide