Buttonhole Sewing - Toyota SP200 Series Instruction Manual

Buttonhole sewing

Buttonhole sewing to match the size of the button is possible.
For stretch fabric or thin fabric, it is recommended to use a stabilizer for a better
buttonhole finish.
Caution
Before changing the presser foot, use the main power switch to turn
off the sewing machine.
Not doing so could cause an injury.
1
1
Change to the buttonhole foot.
Set the stitch length dial between "0.4" and "1".
Buttonhole foot
(For details on changing the presser foot, refer to "Changing the presser
foot" on page 26.)
1
2
Set the buttonhole size and
mark lines on the fabric.
1
Align the buttonhole foot
division line closest to you
with the guide line, and lower
the presser foot to the start
line of sewing on the fabric.
36
Button thickness
(Button diameter+button thickness+3mm)
Division line
Guide line
0.4~1
1 2 3 4
Center line
3 mm
Start line of
sewing
Start line of sewing
Center line