Platform Operation - Carscop CCTR-630 User Manual

Gps watch tracker

Hide thumbs

Table of Contents

supplier to confirm. If sending SMS can locate, but the location can not check on the app or web, please

confirm the APN setting is right.

17. Check Watch Current Setting

Send SMS "test#" to the tracker with authorized number (center or slave center number), the tracker will

reply current setting to user by SMS, this command can be used to check the watch working status, and to

adjust the watch is working well or not. The following is an example:

ver:TQ-v0.1-2014/09/28-22:51;ID:1456301688;ip:58.64.155.133;port:8500;center:13987654321;slave:138765

43210;upload:300s;work mode:1;bat level:3;signal level:100; GPS:OK(7); GPRS:OK(100); LED:OFF;

Ver: Software version time

ID: Tracker ID number

Ip,port: Platform IP & port

Center: Cneter number

Slave: Slave number

Upload: Upload time interval

Workmode: Working mode

Bat level: Battery Level

Signal level:100: GSM signal level

GPS: Satellite number

GPRS: GPRS signal level

LED: LED ON or OFF

18. Reset Watch Tracker

Send SMS "reset#" to the tracker with authorized number (center or slave center number), the tracker will

power off and power on again, some time the tracker can not online, send the reset command, the tracker will

re-power on a few minutes later.

19. Restore to Factory Setting (Back to Default)

Send SMS "factory#" to the tracker with authorized number (center or slave center number), the tracker

will delete all user setting, and restore all setting to factory mode, just like a new tracker, and the tracker will

repower on after delete user setting. If the user have changed the setting, such as APN, IP, center number, etc,

you need set this again after back to factory mode

20. Upgrade Firmware

Send SMS "upgrade,address#" to the tracker with authorized number (center or slave center number),

address is the internet address of the new software, the tracker will upgrade the firmware with the internet

software, after the upgrading, all the user setting will be deleted, this command is used to upgrade future

function for special user.