Sony Handycam Digital8 DCR-TRV238E Operating Instructions Manual page 99

Dubbing only desired scenes
– Digital program editing
(on tapes)
Step 2: Setting the VCR to
operate with the A/V
connecting cable
To edit using the VCR, send the control signal by
infrared rays to the remote sensor on the VCR.
When you connect using an A/V connecting
cable, follow the procedure below, steps (1) to
(4), to send the control signal correctly.
(1) Set the IR SETUP code
1 Set the POWER switch to PLAYER on your
camcorder.
2 Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera recorder,
set its power switch to VCR/VTR.
3 Press MENU to display the menu settings.
4 Turn the SEL/PUSH EXEC dial to select
then press the dial.
5 For DCR-TRV238E/TRV239E:
Turn the SEL/PUSH EXEC dial to select
VIDEO EDIT, then press the dial.
For DCR-TRV340E:
Turn the SEL/PUSH EXEC dial to select
TAPE in VIDEO EDIT, then press the dial.
6 Turn the SEL/PUSH EXEC dial to select EDIT
SET, then press the dial.
7 Turn the SEL/PUSH EXEC dial to select
CONTROL, then press the dial.
8 Turn the SEL/PUSH EXEC dial to select IR,
then press the dial.
9 Turn the SEL/PUSH EXEC dial to select IR
SETUP.
0 Turn the SEL/PUSH EXEC dial to select IR
SETUP code number of your VCR, then press
the dial.
Check the code in "About IR SETUP codes."
(p. 101)
(1)
1
2
,
3
4
5
6
7
8
9
0
(1) (4)
99