Notices; Important Safety Instructions - Epson Stylus CX6300 Quick Reference Manual

Notices

Important Safety Instructions

Before using your EPSON Stylus CX6300, read and follow these safety instructions:
Be sure to follow all warnings and instructions marked on the Stylus CX6300.
Use only the type of power source indicated on the Stylus CX6300 label.
Connect all equipment to properly grounded power outlets. Avoid using outlets on the same
circuit as air control systems or other high-load devices that regularly switch on and off.
Place the Stylus CX6300 near a wall outlet where the plug can be easily unplugged.
Do not let the power cord become damaged or frayed.
If you use an extension cord with the Stylus CX6300, make sure the total ampere rating of the
devices plugged into the extension cord does not exceed the cord's ampere rating. Also, make
sure the total ampere rating of all devices plugged into
the wall outlet does not exceed the wall outlet's ampere rating.
Avoid electrical outlets controlled by wall switches or automatic timers.
Keep your Stylus CX6300 and computer system away from potential sources of
electromagnetic interference, such as loudspeakers or cordless telephone base units.
Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or
dust.
Leave enough room around the Stylus CX6300 for sufficient ventilation.
Do not place the Stylus CX6300 near a radiator or heating vent or in direct sunlight.
Place the Stylus CX6300 on a flat, stable surface that extends beyond its base in all directions. It
will not operate properly if it is tilted or at an angle. Leave enough space in front of the
Stylus CX6300 (at least 23 cm [9 inches]) so it doesn't tip forward and fall off of the work
surface.
Turn off and unplug the Stylus CX6300 before cleaning. Clean with a damp cloth only. Do
not spill liquid on it.
Always turn the Stylus CX6300 off using the On button. Don't turn off the power using a
switch on a power strip or unplug the Stylus CX6300 until the On light is off.
Do not block or cover openings in the Stylus CX6300 case or insert objects through the slots.
Except as specifically explained in your documentation, do not attempt to service the
Stylus CX6300 yourself.
Unplug the Stylus CX6300 and refer servicing to qualified service personnel under the
following conditions: if the power cord or plug is damaged; if liquid has entered the product; if
the product has been dropped or the case damaged; if the product does not operate normally or
exhibits a distinct change in performance. Adjust only those controls that are covered by the
operating instructions.
43
Notices