Fitting The Carbon-Brush - Permobil Chairman Robo PG8 Service Manual

Changing the carbon-brush in the drive motor
Fitting
1. Fit a new brush holder using the fitting ring
provided with the new brush holder. Ensure
that you turn the cables in the same
direction as the outgoing shaft of the gear.
2. Fit the end with two nuts.
Remember the wave washer between the
bearing and the end. Ensure that you
assemble the parts according to the marking
made earlier.
It is important for the function of the motor
that the parts are assembled precisely
without being moved away from the original
position.
3. Insert the mounting plate, cover and brake
disc. Ensure that you position the holes
correctly for fitting the brake.
Turn the brake so that the brake arm is in
the correct position.
4. Screw the motor cables to the plinth.
5. Fit the drive motor. See page 17.
20
Marking