Permobil Chairman Robo PG8 Service Manual page 34

DP1c programming unit
Turn Accel´n
Here it is possible to set how fast/slowly the chair is to reach the maximum turn speed. Set the desired
value with the arrow keys, up = increase in value, down = reduction, between 0 and 100. Then press
Enter. See the table for the normal value.
Turn Decel´n
Here it is possible to set how fast/slowly the chair is to stop turning. Set the desired value with the
arrow keys, up = increase in value, down = reduction, between 0 and 100. Then press Enter. See the
table for the normal value.
Forward Speed
Here it is possible to set the maximum and minimum forward speeds. Set the desired value with the
arrow keys, up = increase in value, down = reduction, between 0 and 100. Then press Enter. See the
table for the normal value.
Reverse Speed
Here it is possible to set the maximum reverse speed. The minimum speed is calculated from the
forward speed. Set the desired value with the arrow keys, up = increase in value, down = reduction,
between 0 and 100. Then press Enter. See the table for the normal value.
Turning Speed
Here it is possible to set the maximum and minimum turning speeds. Set the desired value with the
arrow keys, up = increase in value, down = reduction, between 0 and 100. Then press Enter. See the
table for the normal value.
NB. Adjust with great care.
Speed State
States whether the maximum speed setting is possible. Answer Yes or No and press Enter.
Normal setting = Yes.
Response State
Possible future parameters. Answer Yes or No and press Enter. Normal setting = No.
Present Unit
Resets all parameters to the most recent basic settings. Answer Yes or No and press Enter.
Set Inhibit
Here it is possible to set how inhibit (stop driving) is to function. First answer Yes or No to the question
about whether the chair is to stop in the event of a short-circuit and press Enter, then answer Yes or
No to whether there is be an alternate function for inhibit and press Enter. Normal setting = No/No.
Set Sleep Mode
Here it is possible to determine whether the chair is to switch itself off if it is inactive for more than 5
minutes. Answer Yes or No and press Enter. Normal setting = No.
Park Brake Trip
Here it is possible to set whether the chair is to sense the magnetic brakes. Answer Yes or No and
press Enter. Normal setting = Yes.
Set Steering
Straight trim. Trim with the arrow keys: arrow up (+) = trim to the right, arrow down (-) = trim to the left.
Press Enter to confirm the trim. Applies from V4 of the electronics.
Show Settings
Shows all settings which have been made. Press Enter again to exit the display.
Back to Root
Return to the root menu.
34