Disconnecting The Cables; Installing 3Com Software Utilities - 3Com Megahertz Series User Manual

Disconnecting the
Cables
Installing 3Com
Software Utilities
The LAN and modem cables lock in place when connected to the card. To release
the cables, squeeze the release clips located on the sides of the connector.
CAUTION: Do not pull or attempt to disconnect the cable without squeezing
the release clips. Otherwise, you may damage the card and make it inoperable.
If you did not install the WorldPort country selection software when you installed
this manual, do so now. You can also install a print version of this Guide.
1 Put the Installation CD in the CD-ROM drive.
2 Open the Start menu and select Run.
3 Open D:\SETUP and click OK. (This assumes that D is your CD-ROM drive. If your
system uses another device designation, use that instead.)
For Windows 95 users, the setup utility checks whether your version of Windows
95 correctly manages multifunction cards. You may be asked run a separate utility
if there is a potential problem. If so, go to the following Web site:
http://support.3com.com/infodeli/tools/nic/3ccfem656b.htm
Select Additional Files.
Follow the link to "Updated Microsoft files for proper installation."
Follow the instructions for installing the Microsoft update.
4 Use the check boxes to select which components to install.
If you have not yet installed the WorldPort country selection software, do so now.
You will need to run WorldPort after installing the modem. (WorldPort will run
correctly only if the modem is installed and set up.)
5 To install a print version of this manual, select User Guide -- Print Version. Acrobat
Reader is required for printing. If you do not have Acrobat Reader installed on your
computer, install it from the Installation CD:
Open D:\Acrobat.
Double-click the Acrobat Reader installation file.

Disconnecting the Cables

5