Kubota T1880 Operator's Manual page 54

C PTO belt replacement
1. Remove the belt support bracket, the belt support and
the PTO belt.
(1) Belt support bracket
(2) Wing bolt
(3) PTO belt
2. Hang the PTO belt on the pulley.
While inserting the belt support into the hole of the
mower deck, fasten the bolt.
(1) Belt support
(2) Belt support bolt
(3) PTO belt
(4) Hole of the mower deck
3. Attach the PTO belt to the engine pulley then attach
the belt support bracket.
(1) Belt support bracket
(2) Wing bolt
(3) PTO belt
[Belt support bracket attaching and adjustment]
Adjust the belt support bracket to the following
specification with the PTO lever in the "ENGAGED"
position and tighten the belt support bracket.
To avoid personal injury:
A Make sure engine is not running.
(1) Belt support bracket (A) Clearance between belt support
(B) Clearance between belt support
PERIODIC SERVICE
bracket and pulley. 1 to 2 mm
(3/64" to 5/64")
bracket and belt. 6 to 7 mm
(15/64" to 9/32")
39