Parking; Transporting; Hydrostatic Transaxle Bypass Rod - Kubota T1880 Operator's Manual

PARKING

BParking
To avoid personal injury:
Before leaving the operator's position:
A Apply parking brake.
A Lower all implements to the ground.
A Shut off the engine.
A Remove the key.
1. When parking, be sure to set the parking brake.
To apply the parking brake;
Depress the brake pedal firmly and the parking brake
lock pedal simultaneously with your right foot. Then
release the brake pedal while holding the parking
brake lock pedal down.
2. Before getting off the machine, disengage the PTO,
lower all implements to the ground, set the parking
brake, stop the engine and remove the key.
3. If it is necessary to park on an incline, be sure to chock
the wheels to prevent accidental rolling of the
machine.
(1) Chocks
OPERATING THE MACHINE

TRANSPORTING

1. Transport the machine on a trailer.
A Fasten the machine to the trailer.
A To prevent the hood from opening by wind while in
transit, it is necessary to either load the machine
forward or use a suitable tie down for the hood.
2. Do not attempt to tow this machine, or damage to the
transmission may result.
BHydrostatic Transaxle Bypass Rod
A Do not push the machine without pulling the bypass
rod or transmission damage may occur.
A Never pull the rod with the engine running.
1. To push the machine, pull the HST bypass rod and
hold it.
2. After moving the machine, release the rod and it will
return automatically to normal position.
(1) HST bypass rod
21