Troubleshooting - Lanzar Vibe VBD300 Owner's Manual

Pll synthesizer stereo radio with compact disc player digital
Table of Contents

Advertisement

TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your nearest service dealer.
Symptom
No power.
Disc cannot
be loaded or
ejected.
No sound.
The operation
keys do not
work.
Sound skips.
The radio does The antenna cable is not
not work. The
radio station
automatic
selection does
not work.
Cause
The car ignition is not on.
The fuse is blown.
Presence of CD disc
inside the player.
Inserting the disc in
reverse direction.
Compact disc is extremely Clean the disc or try to play a new
dirty or defective disc.
Temperature inside the
car is too high.
Condensation.
Volume is in minimum.
Wiring is not properly
connected.
The built-in microcomputer Press the RESET button.
is not operating properly
due to noise.
The installation angle is
not more than 30 degrees.
The disc is extremely dirty
or defective disc.
connected.
The signals are too weak.
www.lanzar.com
Solution
If the power supply is properly
connected to the car accessory
terminal, switch the ignition key to
"ACC".
Replace the fuse.
Remove the disc in the player, then
put a new one.
Insert the compact disc with the
label facing upward.
one.
Cool off or until the ambient
temperature return to normal.
Leave the player to off for an hour
or so, then try again.
Adjust volume to a desired level.
Check wiring connection.
Front panel is not properly fixed into
its place.
Adjust the installation angle to less
than 30 degrees.
Clean the compact disc. Then try to
play a new one.
Insert the antenna cable firmly.
Select a station manually.
88-C0851-27

Advertisement

Table of Contents
loading

Table of Contents