Table of Contents
Related Manuals for Lanzar VBD2400U
Summary of Contents for Lanzar VBD2400U
-
Page 1: Instruction Manual
VBD2400U INSTRUCTION MANUAL ANTI-THEFT FLIP DOWN DETACHABLE SYSTEM CD/ MP3 PLAYER WITH MMC/SD SLOT,USB SOCKET WITH ELECTRONIC ANTI- SHOCK FUNCTION AM/FM-STEREO DIGITAL PLL TUNING RADIO INFRARED REMOTE CONTROLLER http://www. lanzar. com... -
Page 2: Specification
SPECIFICATION Preface GENERAL Thank you for purchasing this car audio product. Supply Voltage DC 12 V. Negative Ground Please read this manual carefully before operating this car audio product. Current Consumption Max.10A Please keep this manual for future use. It will be helpful to you if you are encounter any Power Output 80Watts X 4 (Measured at DC 14.4 V) operational problem. -
Page 3: Troubleshooting
LOCATION AND FUNCTION OF CONTROLS TROUBLE SHOOTING Fig. 1 Before using the check list please make all the connections first. If you still have questions after going through the checklist, please consult your local customer service representative. Common Symptoms Cause Solution If the power supply is properly connected to The car ignition is switched off. -
Page 4: Care For Using Cd's
BASS CONTROL 1) Press SEL button to select the bass mode until BAS appears on the display. 2) Rotate the VOL knob to adjust the bass. TREBLE CONTROL CARE FOR USING CD'S: 1) Press SEL button to select the treble mode until TRE appears on the display. 2) Rotate the VOL knob to adjust the treble. - Page 5 3. POWER ON/OFF When the unit is power off, the unit comes to ON by pressing any button on the front panel (except the OPEN key). It also can turn on the unit to insert a disc, MMC/SD card or USB bar into their slots or socket. When the unit is power on, press and hold the power button for more than 0.5 seconds, the unit goes into power off mode.
-
Page 6: Infrared Remote Control Sensor
10. INFRARED REMOTE CONTROL SENSOR WIRING DIAGRAM 11. A.P BUTTON (Auto-storage /Preset scan) During radio mode: ANTENNA PLUG 1) when long pressing for more than 1 seconds, the radio searches from the current frequency and checks the signal strength level until 1 cycle search is finished. -
Page 7: Maintenance Of Remote Control
MAINTENANCE OF REMOTE CONTROL b) During disc, MMC/SD or USB mode: An insulation tag was installed in your remote by the manufacturer to prevent the Press the TOP/ >|| button briefly to interrupt the playback of the disc, MMC/SD battery from draining. Removing the tag from the remote before using. or USB. -
Page 8: Operation Of Remote Control
20. LOC/DX BUTTON OPERATION OF REMOTE CONTROL Radio station search mode is divided by this LOC/DX switch, this button can be used to control an attenuator in the tuner during search. The detecting level 1. Power On/Off. of seek, scan, auto-memory will be reduced as much as the attenuated level of the tuner.