1. Manuals
  2. Brands
  3. Lanzar Manuals
  4. Car Receiver
  5. VBD 1600
  6. Owner's manual

Lanzar VBD 1600 Owner's Manual

Pll synthesizer stereo radio with compact disc player digital
Hide thumbs
Table of Contents

Advertisement

Quick Links

OWNER'S MANUAL
VBD 1600
PLL SYNTHESIZER STEREO RADIO WITH
COMPACT DISC PLAYER DIGITAL

Advertisement

Table of Contents
loading

Related Manuals for Lanzar VBD 1600

Summary of Contents for Lanzar VBD 1600

  • Page 1 OWNER’S MANUAL VBD 1600 PLL SYNTHESIZER STEREO RADIO WITH COMPACT DISC PLAYER DIGITAL...

  • Page 2: Installation

    INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. •...

  • Page 3: Din Rear-Mount (Method B)

    1. Dashboard 2. Nut (5mm) 3. Spring washer 4. Screw (5 x 25mm) 5. Screw 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle. (Fig.

  • Page 4: Wiring Connection

    WIRING CONNECTION MAIN UNIT ANTENNA CONNECTOR SUBWOOFER CABLE (GREEN) IGNITION SWITCH (B+) (BROWN) Rch RED YELLOW FRONT RCA CABLE MEMORY CHOKE BACK-UP Lch WHITE BLACK GROUND (B–) (GREY) Rch RED REAR RCA CABLE BLUE POWER Lch WHITE ANTENNA WHITE GREY FRONT Lch FRONT Rch SPEAKER...

  • Page 5: Operation

    OPERATION Fig. 1 10 3 16 17 Fig. 2 Fig. 3...

  • Page 6: General Operation

    GENERAL OPERATION • ON/OFF/ILLUMINATE As show in Fig. 1, press the hidden wireframe to turn on the unit, the front panel’s state will change into Fig. 2. Press /ILL button (9) shortly to control the brightness of VFD. Press it for several seconds to turn off the unit and the state will change into Fig.

  • Page 7: Radio Operation

    • RESET Reset button (19) is placed on the panel and must be activated with either a ball point pen or thin metal object. The reset button is to be activated for the following reasons: - Initial installation of the unit when all wiring is completed. - All the function buttons do not operate.
  • Page 8 CD OPERATION • DISC PLAY Gently insert a compact disc with the label side facing up into the disc slot (5). The disc is then automatically loaded into the unit and starts playing with the first track of the disc. The digital display will indicate the track number. Then you can press (Eject) button (4) to stop CD play and eject CD from slot or press OPEN...

  • Page 9: Control & Function Keys

    Remote Control Handset CONTROL & FUNCTION KEYS 1. POWER = Power ON/OFF Button 2. MOD = Mode Button 3. S = Select Button 4. DSP = Display Button 5. BND = Band Select Button 6. AMS = Automatically Memory Storing & Program Scanning Button 7.

  • Page 10: Specification

    SPECIFICATION GENERAL Power Supply Requirements : DC 12 Volts, Negative Ground Chassis Dimensions : 178 (W) x 155 (D) x 50 (H) Tone Controls : ± 10 dB - Bass (at 100 Hz) : ± 10 dB - Treble (at 10 KHz) Maximum Output Power : 4 x 60 Watts Current Drain...

  • Page 11: Troubleshooting

    TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom Cause Solution No power. The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to “ACC”.
  • Page 12 88-C1140-33...

Table of Contents