Nvr Pre-Installation; Hard Disk Installation; Nvr Installation - HIKVISION DS-7104NI-SL Quick Operation Manual

Quick Operation Guide of DS-7100NI-SL Series NVR
Thank you for purchasing our product. If there is any question or request, please do not hesitate to contact dealer.
This manual is applicable to the models listed in the following table.
Series
7100NI-SL

NVR Pre-Installation

The DS-7100NI-SL series NVR are highly advanced surveillance equipment that should be installed with care.
Please take into consideration the following precautionary steps before installation of the NVR.
1. Keep all liquids away from the NVR.
2. Install the NVR in a well-ventilated and dust-free area.
3. Ensure environmental conditions meet factory specifications.
4. Install a manufacturer recommended HDD.

NVR Installation

During the installation of the NVR:
1. Use brackets for rack mounting.
2. Ensure there is ample room for audio and video cables.
3. When installing cables, ensure that the bend radius of the cables are no less than five times than its diameter.
4. Connect both the alarm and RS-485 cable.
5. Allow at least 2cm (≈0.75-inch) of space between racks mounted devices.
6. Ensure the NVR is grounded.
7. Environmental temperature should be within the range of -10 º C ~ 55 º C, 14º F ~ 131º F.
8. Environmental humidity should be within the range of 10% ~ 90%.

Hard Disk Installation

Before you start:
Before installing a hard disk drive (HDD), please make sure the power is disconnected from the NVR. A factory
recommended HDD should be used for this installation.
1 SATA hard disks can be installed on your NVR.
Tools Required: Screwdriver.
Steps:
1. Remove the cover from the NVR by unfastening the screws on the bottom.
2. Place the HDD on the bottom of the device and then fasten the screws on the bottom to fix the HDD.
Model
DS-7104NI-SL
DS-7108NI-SL
1
Type
Network Video Recorder