Beeper Definitions - Motorola DS9208 Product Reference Manual

2 - 2 DS9208 Product Reference Guide

Beeper Definitions

The digital scanner issues different beep sequences and patterns to indicate status.
sequences that occur during both normal scanning and while programming the digital scanner.
Beeper Definitions
Table 2-1
Beeper Sequence
Standard Use
Low/medium/high beeps
Short beep
(tone programmable)
4 low beeps
5 low beeps
Low/low/low/extra low beeps
High beep
Image Capture
Low beep
High/low beeps
Parameter Menu Scanning
High/low beeps
Low/low beeps
High/low/high/low beeps
ADF Programming
High/low beeps
Low/low beeps
High/high beeps
High/low/high/low beeps
High/low/low beeps
Low beep
Low/high/high beeps
Low/high/low/high beeps
Low/high/low beeps
Low/high beeps
Power up.
A bar code symbol was decoded (if decode beeper is enabled).
Transmission error.
Conversion or format error.
RS-232 receive error.
The digital scanner detected a <BEL> character over RS-232.
Snapshot mode started or completed.
Snapshot mode timed out.
Input error; incorrect bar code, programming sequence, or Cancel scanned.
Keyboard parameter selected. Enter value using numeric bar codes.
Successful program exit with change in parameter setting.
Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the End of Message bar code.
ADF criteria or action is expected. Enter another criterion or action, or scan
the Save Rule bar code.
Rule saved. Rule entry mode exited.
All criteria or actions cleared for current rule, continue entering rule.
Delete last saved rule. The current rule is left intact.
All rules are deleted.
Out of rule memory. Erase some existing rules, then try to save rule again.
Cancel rule entry. Rule entry mode exited because of an error or the user
asked to exit rule entry.
Entry error, wrong bar code scanned, or criteria/action list is too long for a rule.
Re-enter criterion or action.
Table 2-1
Indication
defines beep