Worx WG776E.9 Safety And Operating Manual page 7

Cordless lawn mower

Hide thumbs Also See for WG776E.9:

Table of Contents

ASSEMBLY

IMPoRTANT! Before you assemble the

lawn mower, check the accessories according

above information, make sure the accessories are

completed.

1. fITTING The hANdle (see fig.A1- A5)

1) remove the screws (a) on the both side of deck.

(see Fig a1)

2) Insert the Lower Handle Bar into the holes on the

deck. Be sure to carefully align the screw holes

found on the Lower Handles with the screws holes

found on the deck (a). (see Fig. a1 a2)

3) secure the Lower Handle Bars to the deck with the

screws provided (see fig a2) .

4) attach the middle Handle (9) to the Lower Handle

with the Handle knobs assembly (8). after this

is complete, attach the upper Handle (1) to the

middle Handle with the upper Handle knobs

assembly (7) (see Fig. a3).

5) Tightening the two Handle knobs. Check that the

handle is FuLLY secured.

The cam lever pressure can be adjusted by rotating

the upper or the lower Handle knobs clockwise/

counterclockwise (see Fig. a4). DO nOT OVer

TIGHTen.

NoTe: ensure that the bolts are fully inserted through

the handles before adjusting or tightening the Handle

knobs.

Cordless lawn mower

WG776E WG776E.9

Table of Contents

Wg776e