Selecting Staple Mode; Selecting Punch Mode - Lanier 5455 Operator's Manual

Using the Finisher

Selecting Staple Mode

Depending on the finisher that you have, the following staple positions are available:
1
2
3

Selecting Punch Mode

With the optional punch installed, you can have three holes punched into your copy sets.
1
2
3
7 - 4
Top: Staples on the upper left corner, left margin.
Top: Staples on the upper left corner, diagonal.
Top: Staples on the lower left corner, left margin.
Double: Staples on the left margin in two places.
Saddle Stitch: Staples two staples in the center
Touch the desired Staple
Position key.
Using the keypad, enter the number of copy sets you require.
Set the originals in place, then press the Start key.Your copy sets are stapled and
exit to the Finisher Shift Tray.
Touch the Punch key.
Set the originals in place, then
press the Start key. Your copies
will exit on the Finishers Shift
Tray with holes punched in
them.
To remove the paper punch outs
from the finisher, refer to "Removing Punch -outs" on page 8-13.
Using the Finisher