Iv.5 Prog Menu: Brightness, Temperature And Alternation Setting - Bodet HMT Installation Instructions Manual

IV.5 PROG menu: brightness, temperature and alternation setting

1. 1. Go to the PROG menu (see page 15).
2. The brightness value flashes (A1 to A3 and then M1 to
M9). Modify with the [R] button. The values from A1 to A3
are automatic brightness settings (the brightness of the
clock varies according to the ambient lighting). The values
from M1 to M9 are manual brightness settings (the
brightness of the clock is fixed whatever the ambient
lighting). The brightness of the readout is modified in
real time and managed independently per face.
3. Press the [S] button to validate the brightness and move
on to setting of the first alternation parameter.
4. The first alternation parameter flashes (h, t, d, o, u, P, c, F
or -)*. Modify with the [R] button.
5. Press the [S] button to validate the parameter and move
on to setting of the second alternation parameter.
6. The second alternation parameter flashes (h, t, d, o, u, P,
c, F or -)*. Modify with the [R] button.
7. Press the [S] button to validate the parameter and move
on to setting of the third alternation parameter.
8. The third alternation parameter flashes (h, t, d, o, u, P, c, F
or -)*. Modify with the [R] button.
9. Press the [S] button to validate the parameter and move
on to setting of the last alternation parameter.
10. The last parameter flashes (h, t, d, o, u, P, c, F or -)*.
Modify with the [R] button.
11. Press the [S] button to validate the parameter and move
on to setting of the alternation period.
12. The alternation period between the items of information
flashes (2 to 6 seconds). Modify with the [R] button.
13. Press the [S] button to validate the alternation period.
14. If a « Chrono » alternating displayed is programmed in
mode "up" or "down, you must now configure the operating
mode.
«ru» = run, the timer never stops. At the end of the count
"up" or "down", the timer restarts with the programmed set
value.
26