Iii.7 Installation On An Ntp Network - Bodet HMT Installation Instructions Manual

III.7 Installation on an NTP network

An SNTP server periodically transmits the UTC time on the Ethernet network.
The clock automatically sets itself to the right time after receiving several
coherent time messages and applying the time zone configuration.
The NTP server must have a transmission (Poll) period of less than 128 seconds.
Make the connections directly on the terminal strip as shown in the diagram
below or use the adapter supplied enabling connection on an RJ45 connector.
Note: the adapter is a cable equipped with a 5-point terminal strip at one end for
connection to the board and an RJ45 connector at the other end for connection to the
network. This adapter must imperatively remain inside the clock to benefit from the
sealing of the product.
Then move on to programming of the multicast address in the technician menu
(page 28).
14
TX+
TX-
RX+
RX-
Ground