Iii.12 Repeater For Double Sided Clock; Iii.13 Configuration Of Dip Switches; Iii.14 Clocks In Series - Bodet HMT Installation Instructions Manual

III.12 Repeater for double sided clock

Remove a cable gland M20 on the
master unit, pass the connector of
the repeater through the hole and
put the cable gland back. Plug the
connector of the repeater in the socket
(E) of the master unit card (see "III -
Electrical installation",

III.13 Configuration of DIP switches

The DIP switches are set in the factory, but it may be useful when installing
several HMT clocks in series to configure DIP switches 3 to 5.

III.14 Clocks in series

It is possible to connect up to 8 clocks in a serial link.
- Use the DIP switches to program one clock as the master then all the others
as slaves (with a different slave number for each clock). See table above.
- Connect the serial cable on the serial connector of each clock. See
photograph above.
18
Repeater
page 9).
Serial connector
Clock type
HMT LED
HMS LED
Clock
HMT LED
MASTER
HMS LED
Slave 1
Slave 2
Slave 3
SLAVE Slave 4
Slave 5
Slave 6
Slave 7
Master
Dip 1 Dip 2
0 0
0 1
Dip 3 Dip 4 Dip 5
0 0 0
0 0 0
0 0 1
0 1 0
0 1 1
1 0 0
1 0 1
1 1 0
1 1 1