Nikon D200 Repair Manual page 65

・ Solder two wires on the back side of the main PCB unit (#1001).
・ Connect the main connection-FPC (#1035) to the connector of the back side of (#1001).
・ Pass the FPC (#1035) through the hole of the rear body, and fix the main PCB unit (#1001) with three screws
(#1616).
・ Connect the five FPCs to the connectors in the order of ① - ⑤ .
Be careful NOT to forget to connect the FPC of ① .
・ Solder thirteen wires.
Caution: 10-pin wires and buzzer wires must
be put under the convex portion of
the front of the prism. (see below)
Penta prism
Back side of Main PCB (#1001)
- Ａ25 ･
Yellow: Power drive PCB
Black: Charge-SW
Brown: Charge-SW
Red: Charge-SW
Purple:
Battery contact
Blue：FG-ID
-
INC
VBA13001-R.3677.A