Shutter unit
・Attach the both-sided adhesive tape (#245 and
#246) on #31 to collect dust.
※ When attaching, be careful NOT to give
pressure on the shutter side.
Installment of Shutter unit
・Peel off the four pieces of the backing paper (#244) that were attached on the rear body. (ref. Page A2)
・Assemble the shutter unit (#31) into the body.
・Assemble the GND steel plate (#398).
・Tighten three screws (#1541) in order.
・Attach the retaining tape (#956) as shown below.
#398
#956
Position for attaching the both-sided adhesive tape
#246
#31
③
#1541×3
- A4 ・
#31
#31
②
①
-
INC
VBA13001-R.3677.A
#245