Hole Punch Mode - Toshiba e-studio 2550c Copying Manual

3.BASIC COPY MODES
5
Select the desired mode from [MAGAZINE SORT], [MAGAZINE SORT & CENTER
FOLD], [MAGAZINE SORT & SADDLE STITCH], [CENTER FOLD] or [SADDLE STITCH].
Then press [OK].
[MAGAZINE SORT & SADDLE STITCH] and [SADDLE STITCH] are selectable only when the
Saddle Stitch Finisher MJ-1108 or MJ-1037 is installed.
[MAGAZINE SORT & CENTER FOLD] and [CENTER FOLD] are selectable only when the
Saddle Stitch Finisher MJ-1108 is installed.
6
Select other copy modes as required, and then press the [START] button on the control
panel.
7
Combine the copied paper if the center fold mode or
magazine sort & center fold mode is used.
In the center fold mode, paper is folded at the center for every 5
sheets before exiting. If more than 5 sheets of paper are copied,
combine them as shown in the figure.

Hole punch mode

You can punch copied paper when the Hole Punch Unit is installed on the Finisher.
Paper whose size is any of A3, A4, A4-R, B4, B5, B5-R, FOLIO, LD, LG, LT, LT-R, ST-R and COMP, and
whose weight is 60 to 256 g/m
(MJ-6007 / MJ-6008) is available.
Special paper such as OHP film or sticker labels is not applicable.
1
Place paper in the drawer(s).
When using bypass copying, be sure to set the paper size.
2
Place the original(s).
2
(16 to 140 lb. Bond) (MJ-6104) or 60 to 128 g/m
3 BASIC COPY MODES
11~15
11~15 6~10
6~10
1~5
2
(16 to 34 lb. Bond)
Selecting Finishing Mode
1~5
97