•
State — Describes the state of the port as determined by the Spanning
Tree Protocol.
•
Operating Parameters — Allows automatic or manual selection of port
speed and duplex mode.
•
Flow Control Enabled — Allows automatic or manual selection of
support for flow control.
GBIC
The GBIC page allows the user to choose the port type of the gigabit ports.
The default is copper. If the user chooses to use a gigabit interface converter
(GBIC), the setting on this page must be appropriately set.
To save any changes you make in this page for the current session, click
Apply. To reset these fields to their current value, click Reload.
NOTE: This option only
applies to the 3024 if
3048 and 3024 are mixed
in a stack.
45
Web I n t e r f a c e