Spanning Tree
The Spanning Tree page contains links to the following pages that allow you
to specify the parameters of the spanning tree protocol:
•
Bridge Settings
•
Port Settings
Bridge Settings
From the Bridge Settings page, you can enable and configure the Spanning
Tree. The following options are available:
•
Enable — Turns the Spanning Tree on. If you enable the Spanning
Tree, you must complete the following fields:
Hello Time — Sets the interval between configuration messages
–
sent by the spanning tree protocol.
–
Max Age — Sets the amount of time before the system discards a
configuration message.
NOTE: Spanning Tree is
enabled by default.
51
Web I n t e r f a c e