Functions Of Parts And Controls - Sony DXF-C50WA Operating Instructions Manual

Functions of Parts and Controls

qg
qf
qd
qs
qa
a MAG (magnification) indicator
Lights up when the displayed image is magnified (when
the ASSIGN. switch of the MAGNIFICATION function
is set to "ON," or "MAGNIFICATION" in the
MAGNIFICATION menu is set to "ON").
b R TALLY indicator (red)
Lights when the red tally signal is input.
c G TALLY indicator (green)
Lights when the green tally signal is input.
d BATT (battery) indicator
Lights up or flashes, to indicate the status of the battery
attached to the camera as follows.
Lit: The battery is drained.
Flashing: The voltage of the battery has dropped below
the threshold value.
To prevent camera from shutting down, change the
battery as soon as possible after this indicator begins
flashing.
The threshold battery voltage value at which this
indicator begins flashing can be set by the camera. For
details, refer to the operating instructions for the camera.
e Up-tally lamp (red)
The supplied number plate can be attached to this.
28
Functions of Parts and Controls
1 2 3 4 5 6 7 8 9
The lamp lights in the same way as the R TALLY
indicator lights when a red tally signal is input. To enable
up-tally lamp, set the ASSIGN. switch of the UP TALLY
function to "ON," or set "UP TALLY" in the TALLY/
IND menu to "ON."
1)
f BRIGHT control
Adjusts the brightness of the viewfinder image.
1)
g CONTRAST control
Adjusts the contrast of the viewfinder image.
1)
h PEAKING control
Adjusts the sharpness of the viewfinder image.
Turn the control clockwise to make the edges sharper.
1)
These controls do not affect the output signal of the camera.
i Tilt lock knob
Fixes any tilting position.
j Connector
Connect to a camera's VF connector.
Power, video signal and tally signal are supplied through
this connector.
0