Yamaha VK10W Supplementary Service Manual page 82

1
2
2. Install:
1
• Brake pads
• Pad spring
2
Installation steps:
• Connect a suitable hoses 1 tightly to the cali-
per bleed screws 2. Put the other end of this
hose into an open container.
• Loosen the caliper bleed screws and push the
pistons into the caliper with your finger.
• Tighten the caliper bleed screws 2.
• Install the brake pads and pad spring.
3. Check:
• Brake fluid level
4. Check:
• Brake lever operation
A soft or spongy feeling → Bleed brake sys-
tem.
Refer to "AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)" in CHAPTER 2.
32
POWR
BRAKE
TR
Bleed screw:
6 Nm (0.6 m · kg, 4.3 ft · lb)