Installation - Yamaha VK10W Supplementary Service Manual

2
1
È
Î
Ò
Ð
Í
Ï
É
Ê
DRIVE CHAIN HOUSING

INSTALLATION

NOTE:
Make sure that the projection 1 on the shift fork is
properly seated in the shift drum groove 2.
È Properly install the rubber seal onto the drive chain
É Make sure that the bearing seals face towards the
Ê Install the washer as shown.
Ë Be sure to install the spacers in their original posi-
Ì 0.2 ~ 0.7 mm (0.008 ~ 0.028 in)
Ë
Ì
Í Make sure that the bearing does not protrude past
Î 1.8 ± 0.5 mm (0.071 ± 0.020 in)
Ñ
Í
Ï 6 ± 0.5 mm (0.236 ± 0.020 in)
Ð
Ð Stamp side
Ñ 1.8 ± 0.5 mm (0.071 ± 0.020 in)
Ò 5 ± 0.5 mm (0.197 ± 0.020 in)
G
É
For the shaft and drive chain housing installation,
refer to "SECONDARY SHAFT".
26
5. Measure:
• Brake disc thickness a
Measure the brake disc thickness 1 ~ 3 mm
(0.04 ~ 0.12 in) from the edge of the brake
disc.
Out of specification → Replace.
Minimum thickness:
3.5 mm (0.14 in)
1. Install:
• Shift drum
2. During installation, pay attention to the follow-
ing.
housing, making sure that there are no gaps.
drive chain as shown.
tions, otherwise the brake disc and shaft will stick.
the end of the counter gear.
: ESSO beacon 325 grease or Aeroshell grease
#7A
POWR
TR