Table of Contents
Advertisement
Quick Install Overview
See Installation Diagram on page 3 . Contact Wilson Electronics
Technical Support Team with any questions at 866-294-1660 .
1 .
Select a location to install the signal booster that is away
from excessive heat, direct sunlight, moisture and has proper
ventilation . Do not place the signal booster in an air-tight
enclosure .
2 .
Select a location on the roof of the building to install the outside
antenna . Use a cell phone in test mode to find the strongest signal
from the cell tower . Visit www.WilsonElectronics.com to find test
mode function for your particular cell phone . See page 6 .
3 .
Select a location for the inside antenna, preferably in the
center of where the signal needs to be amplified . A minimum
separation distance (combined vertical/horizontal) of 20
feet is necessary for operation . If the inside coverage is not
sufficient you may need as much as 50 feet of separation . See
installation diagram on pages 3 & 4 .
4 .
Run the outside antenna cable to the signal booster and attach
it to the connector labeled "Outside Antenna" on the signal
booster . Run the inside antenna cable to the signal booster
and attach it to the connector labeled "Inside Antenna" on the
signal booster . Note: Be careful when plugging the connectors
in so as not to bend the center pins on the connectors. See
page 8 for more information on running cable .
5 .
Before powering up the signal booster, verify that both the
outside antenna and the inside antenna are connected and
check that all connections are tight . Lightning surge protection
is recommended for all in-building installations . See page 7 .
6 .
The Signal Booster has been packaged with the gain control
knobs adjusted to the highest gain position . If one or both of
the lights are not green, please refer to pages 12-14 .
7.
Warning:
Connecting the signal booster directly to a cell phone
with use of an adapter will damage the cell phone and the
signal booster .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
2
Hide quick links:
Advertisement
Table of Contents
