Installing the Inside Antenna
Find the desired location for the panel antenna . Verify that the
panel antenna and the outside antenna have the necessary
separation (Minimum of 20 vertical/horizontal feet if installed with
signal booster set at a lower gain, for maximum gain you may
need as much as 50 feet of separation) . For optimum results the
antenna should be mounted at least 6 feet off the ground .
Inside
Antenna
Ceiling
Rafters
In some cases, multiple inside antennas may be required, for
instance if you have multiple rooms with poor signal . A signal may
be split by using a splitter . If using more than one inside antenna,
a separation of at least 20 feet is necessary between inside
antennas . See configuration on pages 3 & 4 .
Installing a Wilson Electronics Signal Booster
Select a location to install the signal booster that is away from
excessive heat, direct sunlight, moisture and that has proper
ventilation . Do not place the signal booster in an air-tight
enclosure . Recommended installation locations for in-building
signal boosters are:
• On a shelf
• In a closet
• Near a power outlet
Note: It is important to have adequate air ventilation. Maintain at
least 6 inches of clearance from surrounding objects.
Run the outside antenna cable to the signal booster and attach it
to the connector labeled "Outside Antenna" on the signal booster .
Run the inside antenna cable to the signal booster and attach it to
the connector labeled "Inside Antenna" on the signal booster .
9
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.