Table of Contents
Advertisement
Note: For distances of 20 feet or more, use Wilson low loss coax
cable to prevent significant signal loss.
Note: Be careful when plugging the connector in so as not to
damage the center pins on the connectors.
Warning: An inside antenna must have a separation distance
from all persons that is at least 15 inches for the panel antenna .
Powering up a Wilson Electronics
Signal Booster
1 . Never point the front of a directional outside antenna toward the
inside antenna . See Figures 1 & 2 on page 11 .
2 . Ensure that both the outside antenna cable and the inside
antenna cable are connected to the signal booster and the
connections are tight before powering up the signal booster .
3 . Plug the 6-volt power supply into the signal booster input marked
"6V DC" (carefully, to avoid damaging the center pin) and then
into a wall outlet .
4 . If the signal booster does not have a green light(s), please see
pages 12 & 13 . See page 14 for AG Pro Installer .
5 . If you know that only one frequency band (800 or 1900) is
available in your coverage area (or going to be used), reduce
the gain control on the frequency band that is NOT in use to the
lowest setting . This will reduce the power consumption of the
signal booster .
6 . Using multiple signal boosters in one installation could cause
interference to the cell tower .
7 . Contact Wilson Electronics Technical Support Team with any
questions at 866-294-1660 or email tech@wilsonelectronics .com .
Technical Support hours are 7 am to 6 pm MST .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
10
Hide quick links:
Advertisement
Table of Contents
