Quick Install - Inside Window Mount Option - Wilson Electronics 460001 Installation Instructions Manual

Quick Install - Inside Window
Mount Option
Additional installation options on pg. 6-8
Find the Strongest Cellular Signal
(See page 4 for suggested methods.)
Ready to Install
Inside Window Mount
1. Select a location on the inside of
a window as high as possible and
at least 20 feet from where the
DT4G will be located. Note that this
distance typically requires the window
mount to be in a different room from
where you will locate the DT4G and
Desktop Antenna. The window should
face roughly in the direction of the
strongest cellular signal (see section
headed "Find the Strongest Cellular
Signal" on page 4).
2. Clean the area on the glass with the
alcohol prep pad included in Packet C.
3. Insert the suction cups included in
Packet C into the holes on the Outside
Antenna cradle using a twisting
motion. Press the suction cups onto
the window in the desired location.
Need help? www.WilsonElectronics.com
4. Insert the Outside Antenna into the
cradle.
5. Connect the supplied coax cable to
the antenna lead cable on the Outside
Antenna.
6. Route the cable as desired to the
location of the DT4G. If you need to
connect both coax cables, use the
Cable Connector provided.
7. Connect the coax cable to the DT4G.
Connect the Desktop Antenna to the
DT4G. For instructions on install and
Desktop Antenna placement refer to
page 9.
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
5