Finding The Strongest Signal - Wilson Electronics AG Pro 75 Installation Manual

The outside antenna receives the cell tower signal and sends it
through the cable to the Signal Booster, where it is amplified and
re-transmitted much stronger through the inside antenna into the
room . When the inside antenna picks up a signal from your cellular
device, the Signal Booster amplifies that signal and transmits it
through the cable to the outside antenna and back to the cell tower .
(Note: The Signal Booster will only operate if there is an adequate
signal to amplify.)

Finding the Strongest Signal

When installing your signal booster's outside
antenna, aiming it towards the best signal
source from your service provider is important .
The best way of getting the strongest signal
is to have one person on the roof to rotate
the outside antenna, which is connected
to the signal booster, while the second
person is watching the signal strength
on the phone inside the building . This
allows you to read the signal strength
from the cell tower . Turn the outside
antenna about 45 degrees at a time .
It is preferable to have the phone in
the test mode so the actual signal strength can be read as bars
are not the most accurate . Go to www.WilsonElectronics.com for
help in finding the test mode for your phone . Always make sure the
person inside the building gives the signal time to arrive and register
on the phone . (Between 10-30 seconds for phone to reset to the
new signal reading) . Signal readings usually appear as a negative
number (for example, -86) . The closer you get to zero the stronger
the signal . (See graph below)
.
Signal Strength Graph
EXCELLENT GOOD POOR NO
SIGNAL
-50dB -60dB -70dB -80dB -90dB -100dB -110dB
6
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.