Signal Booster Specifications - Wilson Electronics 460001 Installation Instructions Manual

Signal Booster Specifications

Model Number
Antenna connectors
Antenna impedance
Dimensions
Weight
Frequency
Power output for a single phone (uplink) dBm
Power output for a single received channel (downlink) dBm
Noise Figure (typical downlink/uplink)
Power Requirements
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted
without factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing
signals in order to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it
will reduce gain until a signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects
an oscillation, the Signal Booster will automatically turn the power off on that band. For a detected oscillation the Signal
Booster will automatically resume normal operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any
problematic bands are permanently shut off until the Signal Booster has been manually restarted by momentarily removing
power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster's microprocessor.
Need help?
Frequency 704-746 MHz, 746-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
www.WilsonElectronics.com
DT4G Specifications
SMA-male on the Inside Antenna / F-male on the Outside Antenna
4.5 x 6.44 x 1.19 in. or 11.43 x 16.35 x 3.02 cm
0.4 lbs or 0.18 kg
Maximum Power
700 MHz 700 MHz
Band 17 Band 13
23.7 23.6
Maximum Power
700 MHz 700 MHz
Band 17 Band 13
0.9 -1.0
110-240 V AC, 50-60 Hz, 8 W
Tech Support 866-294-1660
Mon.- Fri. Hours: 7 am to 6 pm MST
460001
50 Ohms
800 MHz 1900 MHz
24.6 23.3
800 MHz 1900 MHz
2.1 6.1
7 dB nominal
1700 MHz
24.9
2100 MHz
5.8
15