Basic Parameters - Brave SlimDP - 01 User And Service Manual

5.3 Basic parameters

Parameter Value
41
v – type of choice v=0 is DTMF tone choice, v=1 is impulse choice
Parameter Value
42
z – sign for prolonging a call * or # (10secs. before the end of the call the
Brave sends signal, after pressing this the Brave prolongs the call)
Parameter Value
43
g – Command order [1-2] (there are 2 to disconnect the Brave from both
relays)
bb – Command for disconnecting the Brave from the phone [2 spaces]
1
/ It is advantageous to set the same command for relay switching on
(parameter 35,36)
aa=cc.
1
– command is always 2 digits, but if you wish to control relay with a single
/
digit from the phone, there is an option to input "*a", where a is a single
number and the star represents an empty space and must be in the first
place
(e.g. at parameters 35,36).
Parameter Value
44
xxxx – service password to programme from a phone (DTMF)
If you forget the password, the following procedure is recommended:
1. Open the Brave front cover;
2. Switch „DIP 2‟ to „ON‟;
3. Call the Brave;
4. Once the Brave picks up the system is in programming regime. In
this regime it is possible to change the password 44xxxx;
5. Switch „DIP 2‟ to „OFF‟; and
6. Close the front cover.
Meaning
Type of choice v – time/impulse
v
Meaning
z
Sign for call prolonging
Meaning
Command for disconnecting Brave from
g bb
the phone
and command for the Brave disconnection aa=bb or
Meaning
xxxx
Service password
BRAVE SlimDP –
(00-99,*0-*9)
(0000-9999)
User and service manual
Basic
0
(0/1)
Basic
*
(* / #)
Basic
155 266
Basic
0000
31