Programming With The Help Of Apc - Programme Brave Set - Brave SlimDP - 01 User And Service Manual

Note.
If you want to keep a connection opened during the programming (prolong the 30
sec time) regime (i.e. before a customer decides what else he wants to be set) then you
can press * or #, the Brave immediately answers with an error tone but will prolong the
time before disconnecting.
4.2 Programming with the help of a PC – programme
BraveSet
To programme the Brave with the PC you will; need to use the special
cable USB-KABslim and programme BraveSet. The Brave will also need to be
connected to a telephone line.
Procedure:
- Connect the Brave SlimDP to the line;
- Connect Brave SlimDP to the PC via the USB cable. The Brave will pick
up a line and within 3 seconds a tone for programming entry will be heard
(see chapter 3.1 Page.19).
- Run programme BraveSet. Until the USB is disconnected the Brave is
connected to the PC and is in programming regime and will not run any
other operations. If you lose connection, you will need to reconnect the
USB cable – the Brave will then pick up.
- Connection between the Brave and the programme is indicated by the
firmware on the bottom.
For ease of orientation the parameters in the BraveSet programme are
marked with the same codes as per the phone programming.
The details about parameter setting can be found in „help‟ of the
programme and also on the manufacturer‟s website www.alphatech.cz.
24 BRAVE SlimDP – User and service manual