Incoming Call; Door Entry System With Keyboard - Module Slimkey - Brave SlimDP - 01 User And Service Manual

sends a notice about the end of the call but choosing a code (parameter 42) it
is possible to pro-long the call. By replacing the handset the call is terminated
(the switchboard phone will send a system busy tone and the system will
disconnect). There is one more option, disconnection of line after repeat
pressing of the same button (parameter 4*).

3.4.2 Incoming call

An incoming call is a call to the system (started by a person inside the
building). After choosing the branch the system is connected and the line
rings, following a set number of rings (parameter 51) the system will then pick
up and it is possible to speak. The options are the same as an „outgoing call‟
(chapter 21)

One exception is in the first 10sec. when it is also possible to input „# and
a service password‟ (parameter 44) directing the system to go to the
programming regime.

Another exception is during incoming call and DIP1 is switched to on
( ) when the system also goes to the programming regime
"SERVIS"
(without a service password).

The final exception is relay controls (parameter 381), when an incoming
call can disable the relay controls.
3.4.3 Door Entry System with keyboard – module SlimKey
If a keyboard module is connected to the system, then it is necessary to set
the following parameters:
Parameters for control second relay is in parameters same for relay 1
(inside Brave SlimDP), but with index relay 2.
For using features in SlimKey is need set in SlimKey parameter –
"connection with SlimDP" to "on". Next is possible dial telephone numbers from
keyboard and control relay 1 by code from SlimKey and from exit button
connected on SlimKey. This settings is on SlimKey, in Brave SlimDP is
connection with SlimKey detected automaticaly.
22 BRAVE SlimDP – User and service manual