Camera Mounting; Troubleshooting - Ganz YCH-03Am Instruction Manual

CAMERA MOUNTING

Moving the tripod set base plate
The camera can be attached to a tripod, fi xer or other mounting device from either the top or
bottom side by using the mounting screw holes (1/4-inch, 20 UNC) of the tripod set base plate.
The tripod set base plate can be moved by fi rst removing the two screws and then attaching
the base plate to the top or bottom.
: Do not use any screws other than those of the tripod set base plate of this
camera. Use of longer screws can damage the camera and use of shorter screws can result in
falling.

TROUBLESHOOTING

Please check the following points before asking for repair.
Symptom
No video image is
displayed.
Blurred image is
displayed.
Bottom attachment
Is the power turned on?
Has the coaxial cable been connected properly?
Has the lens cap been removed?
Has the Auto-Iris mode switch been set properly?
Is the lens clean?
Has the lens focus been set properly?
Has the monitor been adjusted properly?
EG-7
Top attachment
Points to check