APPENDIX B: ASSEMBLING LOUDSPEAKER CABLES
CAUTION:
When wiring Ultra XP loudspeaker cables, it is extremely important that each pin be wired correctly.
Make sure the 48 V DC from the external power supply is wired directly (and only) to the 48 V DC pins on the
Ultra XP loudspeaker connector, and that the polarity is observed (negative to negative, positive to positive) to avoid
damage to the loudspeaker. In addition, make sure that audio pins are wired correctly; polarity reversals for audio sig-
nals affect system performance.
ASSEMBLING PHOENIX-TO-PHOENIX LOUDSPEAKER CABLES
When connecting loudspeakers equipped with Phoenix connectors to the MPS-488HPp power supply, you need a Phoenix
5-pin female to Phoenix 5-pin female cable. The following procedure documents how to assemble this cable.
Assembled Phoenix-to-Phoenix Cable
To assemble a Phoenix-to-Phoenix cable:
1. If the cable has not yet been stripped, strip one end of the cable. Strip the outer shielding by 1 inch and then strip the
black, red, blue, and white wires by 0.275 inch.
1"
2. Insert the five exposed conductors into the five cable holes in a Phoenix 5-pin female cable mount connector. Use the
following wiring scheme.
Pin Destinations for Phoenix 5-Pin Female Cable Mount Connector
0.275"
Pin 1
Black
48 V DC (–)
Pin 2
Red
48 V DC (+)
Pin 3
Shield drain
Audio shield
Pin 4
Blue
Pin 5
White
Audio (–)
Audio (+)
27