Electrical Connection - LinMot C1200 Installation Manual

Installation
The drives must be installed and cooled according to the instructions given in the corresponding
•
documentation.
The ambient air must not exceed degree of pollution 2 according to EN 61800−5−1.
•
•
Ensure proper handling and avoid excessive mechanical stress. Do not bend any components and
do not change any insulation distances during transport or handling. Do not touch any electronic
components and contacts.
drives contain electrostatic sensitive devices which can easily be damaged by inappropriate
•
handling. Do not damage or destroy any electrical components since this might endanger your
health!

Electrical connection

When working on live drives, observe the applicable national regulations for the prevention of
•
accidents.
The electrical installation must be carried out according to the appropriate regulations (e.g. cable
•
cross−sections, fuses, PE connection). Additional information can be obtained from the
documentation.
This product can cause high-frequency interferences in non industrial
•
which can require measures for interference suppression.
Operation
If necessary, systems including drives must be equipped with additional monitoring and protection
•
devices according to the valid safety regulations (e.g. law on technical equipment, regulations for the
prevention of accidents). The drives can be adapted to your application. Please observe the
corresponding information given in the documentation.
After the drive has been disconnected from the supply voltage, all live components and power
•
connections must not be touched immediately because capacitors can still be charged. Please
observe the corresponding stickers on the drive. All protection covers and doors must be shut during
operation.
Protection of persons
•
•
NTI AG / LinMot
Preliminary
Before working on the drive, check that no voltage is applied to the power terminals:
•
The power terminals Ph1+, Ph1-, Ph2+, Ph2- and PWR+ remain live for at
least 5 minutes after disconnecting from the power supplies.
The heat sink of the drive has an operating temperature of > 80 °C: Contact with the
heat sink results in burns.
® www.LinMot.com
C1200 Installation Guide
environments
Page 5/22