Table of Contents
Advertisement
Table 3 Enclosure ID and corresponding loop ID settings
Enclosure ID (En)
1
2
3
4
5
6
15
16
17
To change the enclosure ID:
1.
Press and hold the top push button until the alphanumeric display blinks.
2.
Tap the top push button until the desired enclosure ID is displayed.
3.
Press and hold the lower push button until the alphanumeric display is En.
The updated enclosure ID appears in the alphanumeric display upon completion of the enable
procedure.
4.
Set the loop ID to correspond with the updated enclosure ID (see
Setting the enclosure loop ID (Li)
Set the loop ID to correspond with the enclosure ID. See
To set the loop ID:
1.
Tap the bottom push button until the alphanumeric display is Li.
2.
Tap the top push button.
The loop ID appears in the alphanumeric display.
3.
If the loop ID is set to the correct value (based on the enclosure ID), skip to
continue with
4.
Press and hold the top push button until the alphanumeric display blinks.
5.
Tap the top push button until the loop ID that corresponds with the enclosure ID is displayed (see
Table
3).
TIP:
You can press and hold the top push button to scan through the numbers quickly. Release
the push button as the desired loop ID approaches, and tap the push button until the
correct loop ID appears.
6.
To exit the loop ID display, tap the bottom push button.
The display returns to Li.
7.
Tap the bottom push button until the alphanumeric display is En.
8.
Tap the top push button.
The enclosure ID appears in the alphanumeric display.
Loop ID (Li)
62
54
46
38
2A
1C
0E
00
70
Step
4.
Setting the enclosure loop ID
Table 3
for the enclosure ID and loop ID pairs.
HP StorageWorks 2500 Disk System user guide
(Li)).
Step
6, otherwise
35
Advertisement
Table of Contents
