Cleaning The Spray Arms - Miele PG 8527 Operating Instructions Manual

Maintenance

Cleaning the spray arms

The spray arm jets can get blocked by
particles inside them.
The spray arms should, therefore, be
checked daily.
^ Use a sharp pointed object to push
particles into the spray arm jets, and
rinse well under running water.
Remove the spray arms as follows:
^ Take any mobile units out of the wash
cabinet.
Spray arms in the wash cabinet:
^ Loosen the securing clip on the spray
arm connection and then pull the
spray arm upwards or downwards.
68
Spray arms in mobile units/modules:
^ Loosen the securing clip on the spray
arm connection and then pull the
spray arm downwards.
If the bearings show excessive wear
which could cause operational faults
please contact the Miele Service
Department.
^ After cleaning the spray arms,
replace them and fit the securing
clips.
Check that the securing clips are in
the correct position.
After replacing the spray arms,
rotate them to make sure they move
freely.
,
Make sure that no small metallic
objects or instrument parts have
been attracted to the magnets on
the ends of the spray arms.
Any metallic objects can result in the
spray arm rotation being incorrectly
read.