Table of Contents
Advertisement
TouchPad
Description
TouchPad (includes bracket and cable)
Before removing the TouchPad, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the TouchPad:
1.
Disconnect the TouchPad cable from the system board by lifting the ZIF connector (1), and then
removing the TouchPad cable from the system board connector. The cable is held in place with
adhesive.
2.
Remove three Phillips PM2.0×2.0 broadhead screws (2) that secure the Touchpad to the computer.
3.
Remove the EMI tape from the TouchPad.
4.
Lift and remove the TouchPad (3) from the computer.
Reverse this procedure to install the TouchPad.
42
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page
40).
28).
Spare part number
794302-001
Hide quick links:
Advertisement
Table of Contents
