Table of Contents
Advertisement
4.
Remove the two Phillips PM2.5×8.0 screws (1) and the seven Phillips PM2.0×7.0 screws (2) that secure
the bottom cover to the computer.
5.
Separate the bottom cover from the computer by lifting up at the seam near the display hinges (1), and
then lift the cover up and off the computer far enough to access the USB/audio board connector on the
system board.
NOTE:
the inside of the bottom cover) to the system board. Be sure not to pull the cable loose when lifting the
bottom cover.
6.
Disconnect the USB/audio board cable from the system board by lifting the ZIF connector (2), and then
removing the USB/audio board cable (3) from the system board connector.
30
Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
When you lift the bottom cover, a cable is connected from the USB/audio board (installed on
Hide quick links:
Advertisement
Table of Contents
