Advertisement
17
6
7
1
5. Remove the 5/8" Locknut from the shoulder bolt in the Base(1), position the Low Row Pulley Bracket(22)
over the shoulder bolt and replace the Locknut. Do not over tighten the Locknut.
6. Attach the Low Row Calf Raise Attachment(29) to theBase(1).
NOTE: THE LOW ROW CALF RAISE ATTACHMENT CAN BE CONNECTED TO BASE IN THIS STEP
OR CAN BE CONNECTED AT A LATER TIME, TO ALLOW FOR ADDITIONAL WORKING SPACE.
7. Insert plastic caps(AC & AD) where shown.
H
27
28
AC
H
22
F
H
H
AC
I
8
AC
1. Attach the Rear Upright (2) to the Base(1).
AD
2. Attach the Main Upright(6) to the Base(1)
using the Upright to Base Brackets(7).
3. Install the Top Brackets(17) & the Upper
Guide Rod Support(8) to the Main Upright(6)
& the Rear Upright(2). Do not tighten the three
(3) bolts (I) holding the Upper Guide Rod
Support(8) until the Weight Stack has been
installed.
2
4. Attach the Knee Roller Support(28) to the
Main Upright(6).
ONLY WHERE
M
SHOWN
TYPICAL UNLESS
L
AC
29
5
NOTED
AC
Advertisement
