Advertisement
2
W
R
T
5
19
3
NOTE: Do NOT over tighten bolted connections
where bronze bushings are used.
23. With the Press Arm at its lowest position,
screw the pop pin internals which are attached
to the end of the press arm cable into pop pin
outer sleeve on the Press Arm Outer
Tube(5) and tighten securely. Position the
threaded part of the cable into the slot of the
cable retainer which is attached to the Press
Arm Outer Tube(5); the two jam nuts must
stradle the cable retainer. Remove any slack
from the steel cable to the pop pin and tighten
the two jam nuts against the cable retainer.
V
20
P
S
4
AC
H
AC
1
M
L
BOTH SIDES
17.Attach the Lower Press Arm Support(3)
to the Base(1).
18. Attach the Lower Press Arm(4) to the
Rear Upright(2).
19. Slide the Press Arm Adjustment Tube(19)
into the Press Arm Outer Tube(5). Attach the
Press Arm Outer Tube(5) to the Lower Press
Arm(4).
20. Attach the Press Arm(20) to the Rear
Upright(2).
PRESS ARM
CABLE
POP PIN
JAM NUTS
8
21. Attach the Press Arm
Adjustment Tube(19) to the
Press Arm(20).
22. Insert plastic caps(AC)
where shown.
AC
CABLE
RETAINER
5
Advertisement
